GATEWAY FACTORY RESTORE UPDATE PAGE OF
GATEWAY FACTORY RESTORE SERIAL INTEGRATION YOU

If you release the button sooner than 10 seconds, the gateway will reboot, but will not reset. Press and hold the button for at least 10 seconds. Locate the Reset button on the rear of the gateway, located directly beside the power input.

The portal will now be reset. Press and hold the reset button for 6 seconds, then release. WhyLocate the reset button on the back of your Gateway Portal. This technical note will review this process with you.

You want to start fresh on a gateway after making several configuration changes. On a hidden area of hard drive space to use this restore option Full Factory Recovery-Reformats.The possible reasons for resetting the gateway are: 1.8511854 - Gateway Starter Guide for Windows Vista. The procedure is currently at the bottom of OLH 1000141 Infinet EX Troubleshooting Guide. I performed 5 or 6 factory resets of them a few weeks ago, all just by holding down one of the recessed buttons long enough.

Gateway Factory Restore Serial Integration You

If your DMG1000 is currently configured for serial integration you must use the web interface to disable this feature before the serial port will respond to maintenance commands. It is also important to note that to perform these actions on a DMG1000 you must not have the serial port configured for serial integration. When performing these steps on a DMG2000, you must use COM2 because COM1 is only used for serial integration data and will not respond to any maintenance commands. This is important because the serial port must be used to reset the gateway to factory defaults. The key differences are the fact that a DMG1000 only has one serial port, whereas the a DMG2000 has dual serial ports. You want to start fresh for a new integration after replacing your PBX with a new model.While there are physical differences betweenВ a DMG1000 and a DMG2000 gateway, the steps required to fully reset either gateway to its factory default state are the same.

You can restart your gateway at this point and reconfigure it as needed. After the reset the gateway has an IP address of 10.12.13.74, the username will be adminВ and the password will be IpodAdminВ (case sensitive!). You must type the whole word 'yes' otherwise the reset will not be performed.The settings in your gateway are now reset to the factory defaults.

Gateway Factory Restore Update Page Of

These rules are intentionally not defaulted back to factory during this process and thus require a manual reset to ensure that any modifications done to the rules are not accidentallyВ lost during a reset cycle. This is done simply by creating a zero byte (empty) plain text file named default.adt, uploading it to the gateway via the update page of the web interface, and then rebooting.